The middle ear transmits airborne sound waves to cochlear fluids
Sound waves picked up by the external ear vibrate the eardrum, which in turn mobilizes the ossicular chain of the middle ear. The footplate of the stapes applies a mechanic pressure on the oval window and the vibration reaches the perylymphatic fluid of the cochlea.
Middle Ear: scheme
The eardrum (4) or tympanic membrane separates the external auditory canal from the middle ear which communicates with the nasopharynx via the Eustachian tube (6). The oval window (hidden by the stapes footplate: 3) and the round window (5) separate the middle and inner ears. The ossicular chain: malleus (1), incus (2) and stapes (3) links the eardrum to the oval window. The surface ratio of eardrum to oval window (20/1) allows an adequate energy transfer of the sound pressure between the air and the fluids of the inner ear. The middle ear can be considered as an impedance adapter - without it about 98% of energy would be reflected back.
Eardrum
M. Mondain | Human eardrum (in situ)Ossicles, especially the malleus anchoring in the middle of the membrane, are seen by tranparency. |
| SEM picture of a guinea pig eardrum.The surface of the tympanic membrane is observed from the middle ear and the attached arm of the malleus is seen in the centre. |
Ossicular reflex
An intense sound (> 80 dB) trigger this reflex. A feed-back loop (midbrain) contract mussels (in Human, only stapes), which tighten ossicular chain and results in less energy transfered to the cochlea. This reflex (more details elsewhere) only works for low frequencies (< 2000 Hz).
| - (1) Malleus ; |
This internal view of the middle ear cavity allows understanding of how the ossicular reflex may reduce the transfer function of the ossicular chain. This reflex protects the cochlea against loud sounds, but this type of protection is quite limited:
- as it does not play a significant role above 1 or 2 kHz ;
- as it is absolutely ineffective for impulse noise (fireworks, gunfire etc.)
Another function of the ossicular reflex is to attenuate perception of one's own voice: this is especially important for singers.
| This 3D animation shows clearly the ossicular joints. The surface ration between the tympanic membrane (blue) and the stapes footplate (overlaping the whole oval window) explains the amplification of the middle ear. |
Function of the Middle Ear
The middle ear (ME) transmits acoustic energy from the tympanic membrane (TM) to the inner ear, by allowing adjustment of the difference in impedance between an air environment and a fluid environment.
If the sound pressure waves in the air were applied directly to the inner ear fluid, 99.9% of the acoustic energy would be lost because of their reflection at the air /fluid interface (equating to a loss of approx 30dB).
The middle ear acts as a pressure amplifier: in this way it is able to “capture” the available acoustic energy in the air, and augment the amplitude of the mechanico-acoustic stimuli in the inner ear.
Because of the relationship between the surface areas of the TM (area S1 = 0.6 cm2) and the stapes footplate (area S2 = 0.03 cm2), and because of the interaction of the ME levers (the axis of the ossicular chain passes very close to the incudomalleolar joint, but the two arms of this lever are of unequal length, d1/d2 = ~ 1.3), the pressure amplification is theoretically in the order of x26 (approx 28 dB)
Beware, however! This calculation must be used with caution, because, due to its mechanical characteristics, the behaviour and the efficiency of the ME varies greatly with varying frequency of sound (f). In effect, ME function (similar to any type of mechanical system) depends on the friction (R) of the ossicular joints, the mass of the drum/ ossicular chain, and the rigidity (K) of the various membranes, ligaments, air volume and so on.
More about physics (see below)
Middle Ear transfer function
The mechanisms described above become obvious when one studies the transference function of the ME, ie the complex interaction between amplitude and phase that exists between the acoustic pressure at the entrance to the inner ear (Pv: pressure within the perilymph at the base of the scala vestibuli) and the pressure at the TM (Pt): Pv/Pt.
In humans, the maximum sound amplification possible is 20dB, and this varies greatly with frequency, for example there is a maximum of 13dB amplification at 200 Hz, 20 dB at 1000 Hz, 12 dB at 8000 Hz. (graph: P. Minary)
Auditory thresholds and transfer function of external and middle ear
The shape of the auditory thresholds (shown here in man in a straight line) is equivalent to the global transference properties of the external and middle ear together (dotted line). This holds true for all mammals. (graph: P. Minary)
We can therefore arrive at two conclusions:
- It is the external ear and middle ear together which “model” the curve of the sensory auditory threshold, according to the quantity of acoustic energy transmitted at each frequency.
- The inner ear is a detector whose threshold for each frequency is constant across almost the whole of the audible range (about 1.1 – 18 W in man)!